M1 PLUG:
Pin #1 R/B wired to W at tranny connector (Reverse lights).
Pin #2 Y wired to B at tranny connector (Reverse lights).
Pin #3 Pink to E10 Pin #2 Pink (SP1, no 1 vehicle speed sensor from trip/odo meter)
Pin #4 B to F12 – Black (body plug) (Taco, Tachometer signal)
Pin #5 not connected
Pin #6 wired to ground
Pin #7 wired to D Pin #1 Y/R (oil level - Body plug) - Will rewire using 7M sender
Pin #8 not connected
Pin #9 wired to E2 black/yellow (body plug) ("W" signal for check engine)
Pin #10 to Pin F9 Y/G (Water temp sender for combination meter) – I am using an aftermarket sender
Pin #11 wired to E10 Pin #15
B1 PLUG:
Pin #1 not connected
Pin #2 not connected
Pin #3 not connected
Pin #4 Green to Pin #29 (C15 – G/W) body plug – FP signal to diag (currently have this grounded so that pump comes one when key is on)
Pin #5 B/L to E10 Pin #31 on ECU connection - A/T coil for circuit opening relay
Pin #6 Y not connected
Pin #8 NSW to cruise control clutch switch (MT)… Don’t have?
Pin #7 R/B to E10 Pin #32 on ECU connection - Plus for circuit opening relay
Pin #9 B/O to E10 Pin #1 on ECU connection - Ignition switch
Pin #10 B/W to Pin #54 (E4 – B/L) body plug - to neutral st. switch
Pin #11 Idle Up signal from A/C amplifier --- Needed? Where to connect?
Pin #12 Theft deterrent horn signal --- Needed? Where to connect?
Pin #13 A/C water temp switch --- Needed? Where to connect?
Pin #14 B/O to E10 Pin #1 on ECU connection
Pin #15 SPD signal for cruise control --- Needed? Where to connect?
B2 PLUG:
Pin #1 Airbag signal check connector --- Where to connect?
Pin #4 R/Y to E10 Pin #15 on ECU connection
Pin #6 Violet to D Pin #5 body plug Grey/red (not needed?)
Pin #7 W to E9 Pin #76 on ECU connection - 'N' signal from A/T indicator S/W
Pin #20 Y/L to E9 Pin #64 on ECU connection - IDL
Pin #2 not connected
Pin #2 not connected
E10 & C1 PLUG:
Pin #24 to C1 Pin #2 (Black/Orange - M-Relay)
Pin #31 Black/Red = B+ (Connected to C1 Pin #4 & B1 Pin #7)
- Body plug has two black/orange wires going to one pin. Soldered them to the big fat wire coming from plug B1 Pin #14
Pin #32 Black/Red = B1+ (Soldered to C1 Pin #4 & B1 Pin #7)
Pin #33 W/R C1 Pin #1 (Black/Yellow = BATT)
